Cisco 7912 boot problem

Discussion in 'VOIP' started by newman555, May 8, 2010.

  1. newman555

    newman555

    Joined:
    May 8, 2010
    Messages:
    1
    Hi!

    I have a little problem I just can't figure out. I tried to flash 7912 IP phone following instructions I found on several sites. I used wireshark so I could verify what's happening. After setting up DHCP and TFTP (tftp32d), the phone gets the IP address and it starts downloading firmware (CP7912080001SIP060412A.sbin and then cp7912r.zup) and after the file transfer is complete it goes through the same process over and over.

    Any idea how to solve this? Thank you.
     
    newman555, May 8, 2010
    #1
    1. Advertising

Want to reply to this thread or ask your own question?

It takes just 2 minutes to sign up (and it's free!). Just click the sign up button to choose a username and then you can ask your own questions on the forum.
Similar Threads
  1. RM
    Replies:
    2
    Views:
    1,730
  2. Ng
    Replies:
    4
    Views:
    575
  3. ve12876@yahoo.com
    Replies:
    2
    Views:
    14,479
    IP Endpoints
    Feb 18, 2009
  4. Clarence Donath

    Cisco IP Phone 7912 and Custom Ring Sounds

    Clarence Donath, Jan 20, 2006, in forum: VOIP
    Replies:
    0
    Views:
    3,246
    Clarence Donath
    Jan 20, 2006
  5. Scott Hanson

    Cisco 7912 IP Phone PoE woes

    Scott Hanson, Aug 9, 2006, in forum: Cisco
    Replies:
    3
    Views:
    8,430
    www.BradReese.Com
    Aug 10, 2006
Loading...

Share This Page