Cisco 2811 w/ 4-Port HWIC

Discussion in 'Hardware' started by NetSpecialist, Nov 12, 2008.

  1. NetSpecialist

    NetSpecialist

    Joined:
    Nov 12, 2008
    Messages:
    1
    I have a cisco 2811 router that has three connections coming into it. I would like to be able to utilize one of the first two FE interfaces and an HWIC port both on the same subnet/network and still be able to route to the first FE port. See example:

    FE 0/0 int 192.168.x.x
    FE 0/1 int 10.5.5.1 /24
    The following are HWIC ports:
    vlan 3
    ip address 10.5.5.5/24
    FE 0/0/0 switchport access vlan 3
    FE 0/0/1
    FE 0/0/2
    FE 0/0/3

    I already know that the HWIC requires that a VLAN be setup to access the switch ports. The problem is that I can not utilize the vlan address and the interface addresses do to over lapping IP's. Any help on resolving this would be appreciated!
     
    NetSpecialist, Nov 12, 2008
    #1
    1. Advertising

Want to reply to this thread or ask your own question?

It takes just 2 minutes to sign up (and it's free!). Just click the sign up button to choose a username and then you can ask your own questions on the forum.
Similar Threads
  1. dt1649651@yahoo.com

    4-port FE Switch HWIC and 2811

    dt1649651@yahoo.com, May 6, 2005, in forum: Cisco
    Replies:
    6
    Views:
    5,695
    dt1649651@yahoo.com
    May 10, 2005
  2. bob
    Replies:
    1
    Views:
    1,645
    summi
    Jan 26, 2006
  3. Ranga
    Replies:
    2
    Views:
    2,447
    Ranga
    Dec 12, 2006
  4. AlMills

    Cisco 2811 with HWIC-1FE

    AlMills, Sep 12, 2007, in forum: Cisco
    Replies:
    1
    Views:
    3,660
    elvis.asia
    Feb 25, 2010
  5. Houston SBC

    Cisco 2811 with HWIC-4ESW

    Houston SBC, Oct 2, 2007, in forum: Cisco
    Replies:
    3
    Views:
    6,416
    Houston SBC
    Oct 4, 2007
Loading...

Share This Page