asa route map

Discussion in 'Cisco' started by Joerg, Jun 9, 2009.

  1. Joerg

    Joerg Guest

    hallo,

    I have a question to routes on ASA7.2(1).

    2 group of clients should be connect to same server,
    but over 2 different ways.

    ASA

    Group1 ----- . , ------- ... 10.0.0.1 ....
    (in)G1/0 X G0/0 ---- 10.1.1.1
    Group2 ----- ' ` ------- ... 10.0.1.1 ....
    (dmz)G1/1 G0/1


    - test 1 route interface
    i can configure a route per interface, but
    "Name of interface" seen not refer to incoming traffik

    # route dmz 10.1.1.0 255.255.255.0 10.0.0.1
    # route in 10.1.1.0 255.255.255.0 10.0.1.1
    ERROR: Cannot add route entry, possible conflict with existing routes

    Which purpose has "Name of interface"?


    - test 2 route map
    http://www.broadbandreports.com/forum/r21013284-Config-1-lan-2-wlan-Cisco-ASA-5510
    -> You can't policy route on an ASA


    (config-route-map)# set ?
    route-map mode commands/options:
    metric Set metric value for destination routing protocol
    metric-type Set type of metric for destination routing protocol

    -> ASA unknown "set next-hop"

    - test 3 policy-map

    (config-pmap)# set ip next-hop 10.0.0.1
    ^
    ERROR: % Invalid input detected at '^' marker.

    -> Also policy-map does not seem possible.


    Any suggestion?

    regards Joerg
     
    Joerg, Jun 9, 2009
    #1
    1. Advertising

Want to reply to this thread or ask your own question?

It takes just 2 minutes to sign up (and it's free!). Just click the sign up button to choose a username and then you can ask your own questions on the forum.
Similar Threads
  1. Nuno Cristelo

    route-map -> pre or post routing?

    Nuno Cristelo, Jul 23, 2003, in forum: Cisco
    Replies:
    2
    Views:
    593
    Guest
    Jul 24, 2003
  2. AM
    Replies:
    3
    Views:
    668
  3. Replies:
    1
    Views:
    5,282
    Barry Margolin
    Aug 13, 2005
  4. Replies:
    9
    Views:
    5,610
    Scott Perry
    Aug 7, 2008
  5. Geoffrey Sinclair

    Policy map using policy map

    Geoffrey Sinclair, Jul 27, 2009, in forum: Cisco
    Replies:
    1
    Views:
    594
    bod43
    Jul 27, 2009
Loading...

Share This Page