2948G-L3 config register resets

Discussion in 'Cisco' started by adeen.f@gmail.com, Oct 8, 2007.

  1. Guest

    Hello,

    I was hoping someone would have some helpful input with a weird
    problem:
    Our 2948 works great while it is connected to the power, it boots
    reboots and all the configs are in good order. When the switch is
    disconnected from the power and then reconnected the NVRAM is
    corrupted and the config register is reset (0x101). The switch
    continues to load as if it were the first time it was out of the box.
    What worries me is that the config register won't hold after a power
    failure. That is, I enable break (0x0) and have it load directly into
    the rommon. If I enter a reset command it's fine and loads into the
    rommon again, but once I disconnect the power and turn it back on it
    loads the flash image and I'm back where I started.

    I'm guessing it's some kind of hardware problem. Any suggestions as to
    what it is and where I could have it fixed?

    Thanks,

    Adeen
     
    , Oct 8, 2007
    #1
    1. Advertising

Want to reply to this thread or ask your own question?

It takes just 2 minutes to sign up (and it's free!). Just click the sign up button to choose a username and then you can ask your own questions on the forum.
Similar Threads
  1. Brad Hill
    Replies:
    3
    Views:
    578
  2. Ryan Goolevitch

    Re: System flash and config-register

    Ryan Goolevitch, Oct 15, 2003, in forum: Cisco
    Replies:
    0
    Views:
    485
    Ryan Goolevitch
    Oct 15, 2003
  3. Steve

    Config register in 3725

    Steve, Dec 18, 2003, in forum: Cisco
    Replies:
    0
    Views:
    1,239
    Steve
    Dec 18, 2003
  4. R Siffredi

    Config-register values

    R Siffredi, Feb 6, 2004, in forum: Cisco
    Replies:
    2
    Views:
    7,272
    Joe Rankin
    Feb 7, 2004
  5. Replies:
    5
    Views:
    1,584
    Brian V
    Feb 9, 2007
Loading...

Share This Page