«

[gnfast87]

I have 4 MPLS T1's coming into an Cisco 1841 IAD. This is my vendors equipment. They are handing me an ethernet connection which I have plugged into a Cisco 2960G switch. The problem I am having is my vendor says instead of 6 meg. of MPLS coming in they are seeing something rate limiting the data stream down to 1.5 MEG. in my equipment.

By default, the ethernet port on the switch should handle 6 meg with no problems. Correct?? I can't seem to figure out what is rate limiting the connection.

Any ideas?

Thanks,
BRian