Velocity Reviews - Computer Hardware Reviews

Velocity Reviews > Newsgroups > Computing > Cisco > Help with IOS12.3d9 and a NI-2 PRI

Reply
Thread Tools

Help with IOS12.3d9 and a NI-2 PRI

 
 
A Dickson
Guest
Posts: n/a
 
      02-06-2006
Hey guys, normally I just lurk but I need some help from the
collective mind share. First though sorry for posting more config then
I have to but I'm not sure what is relavant


Before I list my problems I thought I should say that I _seem_ to have
the phsyical ISDN link 2/3 setup properly. There are no errored
seconds, slips, and the 'show isdn status' always show it second. I can
make calls both ways and the audio sounds fine - however the unit isn't
handling the calls quite the way I want

Incoming calls: In coming calls have audio that work, I can see the
digits being passed to the first when a call is coming in and
everything looks good. However the cisco doesn't really seem to be
doing much with those digiits. It answers an incoming call to any
number ( it seems) and just treats it like a normal FXO (I think,
incoming line) and starts to match digits. How can I make it match the
received digits off the dailplan ???????

I can make outgoing calls normally from the sip to PSTN side. However
when I place incoming call to the Cisco it answers any number and gives
me a dialtone, I put a destination that matches a SIP dial-peer it it
connects the call (if it answers in the few seconds before it hangs up)
and then terminates. After the config is also the Cisco 'debug isdn
q921','debug isdn q931' output


My config I'l trying not to post the whole thing, so I'l only posting
snippits


!
interface Serial1:23
no ip address
ip broadcast-address 0.0.0.0
no logging event link-status
isdn switch-type primary-ni
isdn protocol-emulate network
isdn incoming-voice voice
isdn T310 30000
no cdp enable
!
!
!
!
dial-peer voice 999 pots
max-conn 12
destination-pattern 999
port 1:23
!
dial-peer voice 3000 voip
application session
destination-pattern 30..
session protocol sipv2
session target ipv4:192.168.4.250
session transport udp
dtmf-relay rtp-nte
codec g711ulaw
!
destination-pattern 9T
port 1:23
!

debug output:
Feb 6 23:45:02.459: ISDN Se1:23 Q931: CONNECT pd = 8 callref = 0x8004
Feb 6 23:45:02.503: ISDN Se1:23 Q921: Net RX <- INFO sapi=0 tei=0,
ns=127 nr=82
Feb 6 23:45:02.503: ISDN Se1:23 Q931: CONNECT_ACK pd = 8 callref =
0x0004
Feb 6 23:45:02.507: ISDN Se1:23 Q921: Net TX -> RR sapi=0 tei=0 nr=0
Feb 6 23:45:05.155: ISDN Se1:23 Q921: Net RX <- INFO sapi=0 tei=0,
ns=0 nr=82
Feb 6 23:45:05.155: ISDN Se1:23 Q931: DISCONNECT pd = 8 callref =
0x0004
Cause i = 0x8090 - Normal call clearing
Feb 6 23:45:05.159: ISDN Se1:23 Q921: Net TX -> RR sapi=0 tei=0 nr=1
Feb 6 23:45:05.175: ISDN Se1:23 Q921: Net TX -> INFO sapi=0 tei=0,
ns=82 nr=1
Feb 6 23:45:05.175: ISDN Se1:23 Q931: RELEASE pd = 8 callref = 0x8004
Feb 6 23:45:05.199: ISDN Se1:23 Q921: Net RX <- INFO sapi=0 tei=0,
ns=1 nr=83
Feb 6 23:45:05.199: ISDN Se1:23 Q931: RELEASE_COMP pd = 8 callref =
0x0004
Feb 6 23:45:05.203: ISDN Se1:23 Q921: Net TX -> RR sapi=0 tei=0 nr=2
Feb 6 23:45:05.215: %VOIPAAA-5-VOIP_CALL_HISTORY: CallLegType 1,
ConnectionId 6
D0933AD 96A111DA 80C5DB3D A95613E, SetupTime 23:45:02.411 UTC Mon Feb 6
2006, Pe
erAddress 999, PeerSubAddress , DisconnectCause 10 , DisconnectText
normal call
clearing (16), ConnectTime 23:45:03.711 UTC Mon Feb 6 2006,
DisconnectTime 23:4
5:05.185 UTC Mon Feb 6 2006, CallOrigin 2, ChargedUnits 0, InfoType 2,
TransmitP
ackets 74, TransmitBytes 11840, ReceivePackets 72, ReceiveBytes 11520
Feb 6 23:45:05.279: %VOIPAAA-5-VOIP_CALL_HISTORY: CallLegType 2,
ConnectionId 6
D0933AD 96A111DA 80C5DB3D A95613E, SetupTime 23:45:03.569 UTC Mon Feb 6
2006, Pe
erAddress 600, PeerSubAddress , DisconnectCause 10 , DisconnectText
normal call
clearing (16), ConnectTime 23:45:03.699 UTC Mon Feb 6 2006,
DisconnectTime 23:4
5:05.269 UTC Mon Feb 6 2006, CallOrigin 1, ChargedUnits 0, InfoType 2,
TransmitP
ackets 72, TransmitBytes 11520, ReceivePackets 79, ReceiveBytes 12640

 
Reply With Quote
 
 
 
 
A Dickson
Guest
Posts: n/a
 
      02-08-2006
Humpf ...... LALALALALAL Anybody here ???

 
Reply With Quote
 
 
 
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Help with PRI/ISDN recv'ed digits routing A Dickson Cisco 12 07-09-2008 02:18 PM
PRI to PRI with bidirectional channel Carlo Cisco 0 02-14-2006 09:40 PM
EMUTEL 15 port BRI / 2 port PRI ISDN simulator help wanted z400d3 Cisco 0 02-07-2005 10:19 AM
Atlas 550 PRI to Cisco 3620 Channelized PRI port problem jamal Cisco 1 07-25-2003 02:51 PM
Help with ISDN PRI & BRI Wayne Cisco 3 07-12-2003 01:56 PM



Advertisments