«

This is the scenario:

I have a network with Subnet: 192.168.1.0/20
A Cisco 1841 Exists as the default Gateway: 192.168.1.1 Fa0/1, Fa0/2
is 66.43.54.111
A PIX 501 Exists to filter traffic: 192.168.1.254 Inside, 66.43.55.20
Outside

The route so far is 0.0.0.0 0.0.0.0 192.168.1.254, This sends all
traffic out through the PIX 501

If I want the router to be able to access the internet, but not
through the PIX 501, how would I set this up. The next hop router for
66.43.54.111 is 66.43.54.1.

Need a solution since the router already has 0.0.0.0 0.0.0.0
192.168.1.254 in it.

Any help would be greatly appreciated! Thanks.

-Rodney

In article <. com>,
Evolution <> wrote:
>This is the scenario:

>I have a network with Subnet: 192.168.1.0/20
>A Cisco 1841 Exists as the default Gateway: 192.168.1.1 Fa0/1, Fa0/2
>is 66.43.54.111
>A PIX 501 Exists to filter traffic: 192.168.1.254 Inside, 66.43.55.20
>Outside

>The route so far is 0.0.0.0 0.0.0.0 192.168.1.254, This sends all
>traffic out through the PIX 501
>
>If I want the router to be able to access the internet, but not
>through the PIX 501, how would I set this up. The next hop router for
>66.43.54.111 is 66.43.54.1.

I'm confused. Do you have the router and PIX in parallel, both
connected to an outside device (e.g., a switch or second router),
or are the two connected to different ISPs, or are the two in series??