Velocity Reviews - Computer Hardware Reviews

Velocity Reviews > Newsgroups > Computing > Cisco > implementing failover capabilities

Thread Tools

implementing failover capabilities

Posts: n/a
There were two separate networks which resided in two different
buildings at my company's present location which have since been
merged into one network which spans two buildings. Each of these
networks had it's own cisco 2610 router connected to a full T1 line
for internet access. Both of these networks had different internet
service providers. Now that the networks have been merged into one all
of the equipment is now going to be housed in one building. One of the
ISPs (AT&T) has agreed to move its' circuit into the new building. Is
there anyway to utilize only one of the cisco 2610 routers to host both
of the 2 different ISP providers circuits in some type of failover
configuration so that if one isp's circuits goes down the other would
take over. What additional router hardware would we need in order to
accomplish this. Any help would be greatly appreciated. Thanks in
advance, LeRoy.

Reply With Quote

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are Off

Similar Threads
Thread Thread Starter Forum Replies Last Post
cisco ASA/PIX failover and VPN, failover IP access problem Pit Cisco 0 08-27-2008 03:34 PM
implementing swing client to ejb server failover and load balancing Timasmith Java 0 12-02-2006 05:54 AM
Cisco 1400 routers capabilities. Ghazan Haider Cisco 1 07-12-2004 04:26 AM
Stateful NAT failover = yes. Stateful CBAC failover = ???? Alec Waters Cisco 0 06-09-2004 01:38 PM
Cisco 806 - Rate Limiting and Packet Shaping capabilities... Chris Dickens Cisco 0 06-03-2004 11:25 PM