«

This is its show version:

Cisco PIX Firewall Version 6.1(2)
Cisco PIX Device Manager Version 1.1(2)

Compiled on Fri 16-Nov-01 14:28 by morlee

Hardware: PIX-506E, 32 MB RAM, CPU Pentium II 299 MHz
Flash E28F640J3 @ 0x300, 8MB
BIOS Flash AM29F400B @ 0xfffd8000, 32KB

0: ethernet0: address is 0009.b718.b578, irq 10
1: ethernet1: address is 0009.b718.b579, irq 11

Licensed Features:
Failover: Disabled
VPN-DES: Enabled
VPN-3DES: Disabled
Maximum Interfaces: 2
Cut-through Proxy: Enabled
Guards: Enabled
Websense: Enabled
Inside Hosts: Unlimited
Throughput: Unlimited
ISAKMP peers: Unlimited

I would like to upgrade to Firewall Version 6.3(4) and PDM 3.0(2) but I
don't know if this PIX needs some else requeriment.
I have .bin files but I don't know if these are what I need or need
more. They are pdm-302.bin and pix634.bin.

I have instructions to upgrade PDM but I don't know how to upgrade
firewall version.

Any response will be appreciated.

THANKS!

In article <. com>,
jaisol <> wrote:
:Cisco PIX Firewall Version 6.1(2)
:Cisco PIX Device Manager Version 1.1(2)

:Hardware: PIX-506E, 32 MB RAM, CPU Pentium II 299 MHz

>VPN-3DES: Disabled

:I would like to upgrade to Firewall Version 6.3(4) and PDM 3.0(2) but I
:don't know if this PIX needs some else requeriment.

No, your 506E should be able to handle 6.3(4) without difficulty.

:I have .bin files but I don't know if these are what I need or need
:more. They are pdm-302.bin and pix634.bin.

Those are what you need.


:I have instructions to upgrade PDM but I don't know how to upgrade
:firewall version.

http://www.cisco.com/univercd/cc/td/.../c.htm#1026589
--
"[...] it's all part of one's right to be publicly stupid." -- Dave Smey