Wireless USB adaptor

My usb adaptor is connected and the driver is installed. I had not trouble
with it for a while and now it does not work and I get a

Code[10] device will not start


message out of no where. How does that work out?

=?Utf-8?B?WGJsIEplYW4tUGF1bA==?=

Hi
Look at the device manger and make sure that the card is installed correctly
and there is No Ghost.
What is Ghost Hardware Installation? http://www.ezlan.net/faq#ghost
Jack (MVP-Networking).

"Xbl Jean-Paul" <Xbl Jean-> wrote in message
news:F77E38C0-105E-466E-B651-...
> My usb adaptor is connected and the driver is installed. I had not trouble
> with it for a while and now it does not work and I get a
>
> Code[10] device will not start
>
>
> message out of no where. How does that work out?

Jack \(MVP-Networking\).

On 11-Dec-2006, =?Utf-8?B?WGJsIEplYW4tUGF1bA==?= <Xbl
Jean-> wrote:

> My usb adaptor is connected and the driver is installed. I had not trouble
> with it for a while and now it does not work and I get a
> Code[10] device will not start
> message out of no where. How does that work out?

Have you unplugged it from the USB port, waited a couple of
minutes, and plugged it in again? USB port should see it
reconnected and then re-start the connection. My USB
wireless adapter is on a 2-way USB
switch, for 2 PC's. I can also hot
swap my USB external backup drive.
Does Start -> Connect to show your network connection?
You could also try creating another connection, using
the wizard, or using another USB port.

ato_zee@hotmail.com