I need a Cisco AS5300 to be configured to a VOIP gateway.
A call comes in to the PRI (T1) via a person dialing one of our DID's. the AS5300 is connected to the PRI. The AS5300 then needs to convert the call to VoIP then send the call to our PBX via the PBX's IP address.
I'm new to setting up anything cisco or anything via telnet. So things need to be layed out in a simple way. Like cisco's site
"To configure a POTS dial peer for DID, enter the following Cisco IOS commands beginning in global configuration mode: