«

How can I get it into rommon mode and get it's old firmware back into
the flash??

Thanks

Ivan

Hi Ivan,

You may wish to investigate ROMmon Recovery for the Cisco 2600 Series
Router:

http://www.cisco.com/en/US/products/...80094a0b.shtml

Sincerely,

Brad Reese
Cisco IOS Software - Compatible Partner Matrix by Technology
http://www.BradReese.Com
1293 Hendersonville Road, Suite 17
Asheville, North Carolina USA 28803
USA & Canada: 877-549-2680
International: 828-277-7272
Fax: 775-254-3558
AIM: R2MGrant
BradReese.Com - Global Cisco Systems Pre-Sales Support
http://www.bradreese.com/contact-us.htm#CISCO

"Ivan82" <> writes:
>How can I get it into rommon mode and get it's old firmware back into
>the flash??

Send a serial break within 30 seconds of poweron while booting.
issue the tftpdwnld command (to see what variables need to be set,
then set them appropriately) and TFTP the new IOS image down to the router.

It will take you at least 30 minutes to put an boot images ios to the
rom.

We buy sell all Cisco, Discount up to 80% off on New Used Cisco.
LinkWaves Corp
29980 Technology Drive, Suite 6
Murrieta, CA 92563
http://www.linkwaves.com/requestquote.asp
909-725-9143



Ivan82 wrote:
> How can I get it into rommon mode and get it's old firmware back into
> the flash??
>
> Thanks
>
> Ivan