«

I have a PIX 501.

I have it configured the way I want.

I issue a WRITE MEM command.

I make some additional changes that I do not like.

How do I load the configuration from MEM? I know if I power cycle the box
it will reload from mem, but is there a READ MEM, or a reboot command?

Thanks.

--

-----------------------------------------------------------------
Terrence

"TPS" <> wrote in message
news:qoSKc.15087$ om...
> I have a PIX 501.
>
> I have it configured the way I want.
>
> I issue a WRITE MEM command.
>
> I make some additional changes that I do not like.
>
> How do I load the configuration from MEM? I know if I power cycle the box
> it will reload from mem, but is there a READ MEM, or a reboot command?
>
> Thanks.
>
> --
>
> -----------------------------------------------------------------
> Terrence
>
>
Nope.

Reload or remove the commands manually i.e no whatever.

G

G, thanks for your reply.

Upon further research, it looks like the RELOAD command is what I was
looking for.

The reload command reboots the PIX Firewall and reloads the configuration
from a bootable floppy
disk or, if a diskette is not present, from Flash memory.


--

-----------------------------------------------------------------
Terrence

TPS wrote:
> I have a PIX 501.
>
> I have it configured the way I want.
>
> I issue a WRITE MEM command.
>
> I make some additional changes that I do not like.
>
> How do I load the configuration from MEM? I know if I power cycle the box
> it will reload from mem, but is there a READ MEM, or a reboot command?
>
> Thanks.
>
Issue a reload-command.
That's the same as a power-cycle, only software-triggered