«

hi,
Is there a way to block all IPX traffic on
cisco catalyst 2950 switch...
Can u give example if possible..

tia

In article < >,
says...
> hi,
> Is there a way to block all IPX traffic on
> cisco catalyst 2950 switch...
> Can u give example if possible..

I doubt it. I don't know how a L2 only box can block frames based on L3
packet information.


--

hsb

"Somehow I imagined this experience would be more rewarding" Calvin
*************** USE ROT13 TO SEE MY EMAIL ADDRESS ****************
************************************************** ******************
Due to the volume of email that I receive, I may not not be able to
reply to emails sent to my account. Please post a followup instead.
************************************************** ******************

In article <>,
says...
> In article < >,
> says...
> > hi,
> > Is there a way to block all IPX traffic on
> > cisco catalyst 2950 switch...
> > Can u give example if possible..
>
> I doubt it. I don't know how a L2 only box can block frames based on L3
> packet information.
>
>
>

Well, with EMI image it can block IP packets. Not sure about IPX.


--
Ivan

I have bridge that can block IPX based on LLC-frames info...afaik layer3-protocol

> In article < >,
> says...
> > hi,
> > Is there a way to block all IPX traffic on
> > cisco catalyst 2950 switch...
> > Can u give example if possible..
>
> I doubt it. I don't know how a L2 only box can block frames based on L3
> packet information.
>