«

"Joe Harrison" <> wrote in message
news:N1Iwg.59400$
> I have a Sipgate/SPA3000 setup that mostly works fine,
> but in parallel was experimenting using X-lite with
> another account with a different PSTN prefix. For ages
> the second account was behaving as you describe, outgoing
> calls OK but incoming calls not. Depending on which was
> my calling network I got variations on the "number not in
> use" message when trying to call into X-lite.
> So I was convinced the other area code prefix just plain
> didn't work on Sipgate and finally contacted tech support
> - they were very helpful, must have done quite a bit of
> diagnostic work then told me the fault was on my end with
> the X-lite configuration. Which it was, egg on face. So
> if you are running more than one account behind same NAT
> you have to give X-lite a non-default port config e.g.
> 5602.

Yes, I do that with X-Pro (the full version) on my laptop, but other
people were apparently experiencing problems at the same time, so I don't
think it was all you.

Ivor