«

I got a Cisco Lab for Christmas, and ive been practicing a lot of lab
setups. Ive been trying to do a lab, multipoint subinterfaces across
frame-relay. Here is my physical setup right now:

http://www14.brinkster.com/kgoad/frame.jpg
(BTW, the .0.4 and .0..1 stuff you see is the last 16 bits of the
interfaces IP address, I always use 192.168.x.x/24)

The numbers inside the Frame Cloud are the DLCI's for each interface.

I can ping from R0 to the Serial0.1 interface on R2 fine, but i cant get
it to ping anything else. Here are the configs for each:

http://www14.brinkster.com/kgoad/R0.txt
http://www14.brinkster.com/kgoad/R1.txt
http://www14.brinkster.com/kgoad/R2.txt
http://www14.brinkster.com/kgoad/R3.txt

Im pretty sure it has something to do with the subinterfaces on R2, or
the DLCI configuration on R1.


Any idea where i am going wrong?

Thanks

Kevin Goad wrote:
> I got a Cisco Lab for Christmas, and ive been practicing a lot of lab
> setups. Ive been trying to do a lab, multipoint subinterfaces across
> frame-relay. Here is my physical setup right now:
>
> http://www14.brinkster.com/kgoad/frame.jpg
> (BTW, the .0.4 and .0..1 stuff you see is the last 16 bits of the
> interfaces IP address, I always use 192.168.x.x/24)
>
> The numbers inside the Frame Cloud are the DLCI's for each interface.
>
> I can ping from R0 to the Serial0.1 interface on R2 fine, but i cant get
> it to ping anything else. Here are the configs for each:
>
> http://www14.brinkster.com/kgoad/R0.txt
> http://www14.brinkster.com/kgoad/R1.txt
> http://www14.brinkster.com/kgoad/R2.txt
> http://www14.brinkster.com/kgoad/R3.txt
>
> Im pretty sure it has something to do with the subinterfaces on R2, or
> the DLCI configuration on R1.
>
>
> Any idea where i am going wrong?
>
> Thanks
>


Nevermind, I got it. It was here:
frame-relay route 102 interface Serial0 103

serial0 does not equal serial2


And I had my Multipoint Inerface on R2 all wrong, im an idiot.