«

Hi

When I do (PIX506 v 6.1) a show access-list it does not show the 'line x'
parameter for each line. I just have the ACL in itself.
I terminal in the cisco in enable mode.

EG: I would like to have
access-list ac line 1 permit tcp any any
and i just have
access-list ac permit tcp any any

The Pix is suppose to assign a line number to each acl.

Any clues ?

Thanks,

Alex

In article <bog33l$btd$>,
Alex <> wrote:
:When I do (PIX506 v 6.1) a show access-list it does not show the 'line x'
arameter for each line.

:The Pix is suppose to assign a line number to each acl.

Not in PIX 6.1 it doesn't. That feature did not arrive until 6.3(1).

http://www.cisco.com/univercd/cc/td/...rn63.htm#68681

--
Perposterous!! Where would all the calculators go?!