«

I've looked at the instructions for configuring a Cisco switches port
speed and duplex settings, but for some reason, i get the error
incomplete command when trying to go into interface config. Can
someone post the exact command i need to enter after going into config
terminal to set the port speed to 100mb and full duplex for a Cisco
2950 with IOS 12.1(11).
Thanks!

This was done on a 2950 running IOS 12.1(13) but it should be the same for
12.1(11)

Switch#config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#interface fastethernet 0/1
Switch(config-if)#speed 100
Switch(config-if)#duplex full
Switch(config-if)#

and that's it... let us know if there are any other questions.

-John

"jlk" <> wrote in message
news: om...
> I've looked at the instructions for configuring a Cisco switches port
> speed and duplex settings, but for some reason, i get the error
> incomplete command when trying to go into interface config. Can
> someone post the exact command i need to enter after going into config
> terminal to set the port speed to 100mb and full duplex for a Cisco
> 2950 with IOS 12.1(11).
> Thanks!