«

Helo everyone,

I am having a problem getting Cisco 3725 talking to Siemens Hicom 150 E over
E&M trunk. We have confirmed almost everything possible including:
E&M type (type 5)
Signaling (Wink-start)
Operation (4-wire)
T/R and T1/R1 pairs

The cisco box has following config:

voice-port 1/0/0
operation 4-wire
type 5
cptone AU
compand-type A-Law
!
dial-peer voice 1 pots
destination-pattern 20...
port 1/0/0
!
dial-peer voice 60 voip
destination-pattern 60...
session-target ipv4.x.x.x
ip qos dscp cs5 media

When you pickup a handset and dial some extension say 615, the PBX sends (or
should I say is supposed to send) 60615 I don't see the digits in the output
of the debug vpm and vtsp. And I immidiately hear a loud dial tone which we
suspect is coming from the VIC-2EM...


If anyone had similar situation with this PBX could you please help.

Thanks