|
|
|
|
|
|||||||
 |
VOIP - Re: need help with configuring Cisco ATA 186 |
|
|
Thread Tools | Search this Thread |
07-03-2003, 05:58 PM
|
#1 |
Re: need help with configuring Cisco ATA 186
Bulent Cakir <> wrote:
> I'm trying to connect 2 offices in different cities just using ATA186s. I > was able to set them up in local network, and made calls to each other, but > I don't know how to set them to use outside the local network. Can anyone > help me with this? As long as they have publicly routable IP addresses and your firewalls aren't getting in the way, there shouldn't be any difference. miguel Miguel Cruz |
|
|
|
07-04-2003, 01:37 AM
|
#2 |
|
Posts: n/a
|
Re: need help with configuring Cisco ATA 186
On Thu, 03 Jul 2003 16:58:26 GMT, (Miguel Cruz) wrote:
>Bulent Cakir <> wrote: >> I'm trying to connect 2 offices in different cities just using ATA186s. I >> was able to set them up in local network, and made calls to each other, but >> I don't know how to set them to use outside the local network. Can anyone >> help me with this? > >As long as they have publicly routable IP addresses and your firewalls >aren't getting in the way, there shouldn't be any difference. Are you talking about more than one unit? If you only have two, simply set the gateway entries on both units to point to the other. If you have more than one unit, you can either setup a gatekeeper and use that as a gateway, or dial using the IP addresses (ie 123*123*123*123). -Chris |
|
|
|
07-08-2003, 04:01 PM
|
#3 |
|
Posts: n/a
|
Re: need help with configuring Cisco ATA 186
On Tue, 8 Jul 2003 10:05:52 -0400, "Bulent Cakir" <>
wrote: >Hi, > >The problem is these ATA 186 s are behind firewalls. So what should I do >Chris? I don't have much experience with running these through firewalls or NAT. I know solutions have been discussed in this group before . Perhaps a search on groups.google.com will be more helpful. -Chris |
|
|
|
07-13-2003, 06:12 PM
|
#4 |
|
Posts: n/a
|
Re: need help with configuring Cisco ATA 186
Hello!
Bulent Cakir wrote: > The problem is these ATA 186 s are behind firewalls. So what should I do > Chris? Your ATAs will not be able to talk directly to each other then. You will need either: - set up your firewall to pass H323 traffic - or use some third entity (H323 proxy or SIP server) which will facilitate to establish the connection between them WBR, Andrew -- Andrew Zhilenko Please remove "hide-email." from my email address when replying, so my address should be andrew (at) ti dot cz |
|
|
