PIX 6.01 - wont take commands
I'm trying to let port 8003 through to a particular IP address and I use this command
conduit permit tcp host x.x.x.x eq 8003 any
enter it with no errors and when i try to telnet to that IP or use nmap it doesn't show up. I even write mem to no avail. The external IP is set to an internal and we have port 1723 and 9500 open and functioning fine.
any ideas? Would a simple reboot suffice?
I'm new to the PIX equipment but very much like this forum as it seems very active and full of great information.
|All times are GMT. The time now is 07:47 AM.|
Powered by vBulletin®. Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.