Cisco 2811 dmz troubles
I have a Cisco 2811 advsec router, and have added an HWIC FE port and a B/G wireless card into it.
One FE port is my internet connection, one is internal, and one is dmz. I have nat set up, and just the basic firewall from SDM, permitting traffic to my dmz host. No outside traffic is getting through to the dmz host.
I have been over the router many times and can't see anything that I can change to make this work. Is there something I should be looking for? Any ways to tell for sure if this is a firewall, acl, nat or me being a dummy issue?
Thanks in advance.
|All times are GMT. The time now is 03:39 PM.|
Powered by vBulletin®. Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.