bandwidth resevation in cisco 3560 l3 switch
 

hi i got a problem regarding bandwidth resevation in cisco 3560 l3 switch,since rate limit command on that particuler switch is not executed, so i used banwidth reservation command & srr queue banwidth command,but i cannot reserve the bandwidth.So please help me

thank you

The 3560 doesnt support applying service policy's on the egress side of the interface. Shaping should work though:

mls qos
policy-map Police-3M
class class-default
police 4000000 512000 exceed-action drop
!
interface FastEthernet1/0/1
description Police to 4 Mbps
speed 10
duplex full

service-policy input Police-4M
srr-queue bandwidth limit 40

The reason why you have to change the speed on the interface is because the
srr-queue bandwidth limit command only supports a range from 10-90 percent. If we kept the
default 100m on the interface the lowest we could police it down would be to 10m . Since we hard coded the speed on the interface you have to hardcode the speed/duplex on the endstation.

wait guys to helpp