Cisco 1811 with multiple Vlans and internet interfaces
I have a new Cisco 1811 that I am trying to get configured in 1 of
1) 2 Vlan's (vlan 10 employee / vlan 20 vendor) FastEth0 connected to
the internet with a Public IP (X.Y.X.5). IPSec tunnel brought up to
main office and all of vlan 10 routed over it with no NAT. Vlan20
needs to be prevented from accessing the VPN tunnel, but does need
direct internet access over FastEth0 via NAT.
2) Second solution same as first, however the FastEth1 interface is
also configured with a second public IP (X.Y.X.10) on the same subnet
as FastEth0. Thus vlan 20 should be NATed for internet access on
FastEth1 while FastEth0 is used for VPN traffic only.
Will either of these configs work and if so are there any example
configs. I have the Vlans and VPN working, but can not get the NATing
working either way. I'm concerned that one of my ACL's from the VPN
config may be interfering with solution 1 which is my ideal config.
|All times are GMT. The time now is 02:58 PM.|
Powered by vBulletin®. Copyright ©2000 - 2013, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.