How to block certain website
I am new to this, I would like to know
how to block certain website through pix506 - is that possible?
and time scheduled browsing.
Re: How to block certain website
In article <email@example.com .com>,
Anver <firstname.lastname@example.org> wrote:
>I am new to this, I would like to know
>how to block certain website through pix506 - is that possible?
>and time scheduled browsing.
You can get commercial products, Websense or N2H2, which the
PIX will work with to do filtering. These are expensive -- unless
you are a company that needs this kind of facility, in which case
they are a cost of doing business that could end up saving a lot of
The filtering capabilities built directly into the PIX 506 are limited
to IP addresses and ports, not site names. Thus if the users use
a proxy service, even a trivial non-encrypting one, then the PIX 506
would not be able to detect that. And if the web site to be blocked
happens to share IP addresses with other sites, the PIX 506
cannot look to see which name was requested so as to allow the
"good" sites through but not the bad sites.
The highest software version officially supported on the PIX 506
is 6.3(5), which does not support timed ACLs. If you open up
the PIX 506 and increase the memory in it, then you can get
PIX 7.0, 7.1, or 7.2 to load into it and run, and those support
timed ACLs. PIX 7.x is not officially supported in the PIX 506...
and you would need a support contract to have access to PIX 7.x.
|All times are GMT. The time now is 01:06 PM.|
Powered by vBulletin®. Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.