Problem with Cisco Router 1700 and 1800
Hello, I have two routers one Cisco1700, and one 1800 (just added to our private WAN). The network already has quite a number of Cisco 1600s and 800s. I configured everything the way I know it, both the serial and ethernet ports. The problem I have is that if I try to ping the router's ethernet port remotely, it does not work, but I can ping and even Telnet the router's serial port! Both of them. After telnetting it, I am able now to ping the ethernet port and even computers in the router's LAN. But the computers in the router's LAN cannot ping any router outside the WAN except their own, likewise computers outside the router's LAN cannot ping the router. What could be the problem?
I would say this is a routing problem, you are able to ping the serial interface because your interfaces are connected directly.
What you can try is using
ip route 0.0.0.0 0.0.0.0 "Netx hop address/Serial Interface" in each of the routers and then try pinging again
The best way to test what is going on on your network is to type
you have to type out "yes"
Then "Enter" X 2
|All times are GMT. The time now is 05:55 AM.|
Powered by vBulletin®. Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.