MAC list on an 871W
I've got an 871W at home. I'm trying to set it up for open authentication,
but only to allow a single mac (my laptop) to access it. I'm having no luck
figuring out how to attach the MAC acl to the wireless interface, and I'm
hoping someone here can explain. Here are the relevant config bits:
no ip address
speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
access-list 700 permit xxxx.xxxx.xxxx 0000.0000.0000
access-list 700 deny 0000.0000.0000 ffff.ffff.ffff
As configured, it's wide open and anyone can connect. What I'm trying to
figure out is how to associate the ACL with the interface, or if there is
something besides an ACL I should be using. Everything I try ends up with my
laptop being unable to connect.
I tried using SDM, and gave up. Too slow, impossible to find what I need,
etc. Thanks in advance for keeping my neighbor's kids off my WLAN.
John Scholvin -- firstname.lastname@example.org -- an E7b5#9 man in an F major world
|All times are GMT. The time now is 02:06 PM.|
Powered by vBulletin®. Copyright ©2000 - 2013, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.