Help with Nat / Routing
Group, I'm at a loss. I am working with a vendor to get his mobile
unit connected to one of our remote networks.
My internal remote network is 10.1.40.0 255.255.255.0. Everything is
my NETWORK is 10.1.30.0.
>From a workstation at the remote site, I can ping 10.1.30.x fine. From
10.1.30.x I can ping anything at 10.1.40.x fine.
On his side, he has a mobile unit (large truck). In this truck, he as
his own IP scheme.
On his router, he has as a secondary of 10.1.40.100 so that he can
communicate with the remote sites network.
He can ping 10.1.40.2 (the gateway) but CAN NOT ping 10.1.30.11 my
He needs to be able to communicate with both the 10.1.40.x network and
the 10.1.30.x network.
He tried adding a route statement, but couldn't get it to work.
Does anyone have any ideas?
His config looks like this:
ip address 10.1.40.100 255.255.255.0 secondary
ip address 172.17.4.146 255.255.0.0
ip address 172.31.31.1 255.255.255.0
ip nat inside
ip nat pool OURPOOL 10.1.40.100 10.1.40.100 netmask 255.255.255.0
ip nat inside source route-map OURMAP pool OURMAP overload
access-list 109 permit ip 172.31.31.0 0.0.0.255 10.1.40.0 0.0.0.255
access-list 109 permit ip 172.31.31.0 0.0.0.255 10.1.30.0 0.0.0.255
route-map OURMAP permit 10
match ip address 109
Re: Help with Nat / Routing
|All times are GMT. The time now is 10:11 PM.|
Powered by vBulletin®. Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.