MN-700 Disconnects continue after Firmware upgrade
IEEE 802.1x should be disabled unless you are running an
This will cause frequent disconnections.
Also make sure that your Wireless AP is not using the
default frequency channel 6 as it could create
interference from your neighbors AP, if any.
>I upgraded the MN-700 firmware, but continue to see
>between my wireless laptop and our PPPoE DSL connection.
>Microsoft Knowledge Base Article 814080 recommends
disabling IEEE 802.1x
>authentication, but does not suggest whether it should
be turned on or off
>following the FW upgrade.
|All times are GMT. The time now is 09:58 AM.|
Powered by vBulletin®. Copyright ©2000 - 2013, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.