Monitor interface is down
Have monitoring going on a destination port on a C2950:
monitor session 1 source interface Gi0/2
monitor session 1 destination interface Fa0/4 ingress vlan 1
I also had the above without the ingress vlan 1. The Fa0/4 shows up /
FastEthernet0/4 is up, line protocol is down (monitoring)
Hardware is Fast Ethernet, address is 0012.803f.af44 (bia
MTU 1500 bytes, BW 100000 Kbit, DLY 1000 usec,
reliability 255/255, txload 92/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s, media type is 100BaseTX
input flow-control is unsupported output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output 00:09:23, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 36464000 bits/sec, 7881 packets/sec
40958 packets input, 3276630 bytes, 0 no buffer
So what's going on with the protocol down? Can't figure this out!
Re: Monitor interface is down
After doing some research, it looks like I have to have another
interface on the machine to be able to log into. Now my question is can
this interface be in the same lan? I should be able to do this. Because
the monitoring interface will be down anyway?
|All times are GMT. The time now is 10:45 PM.|
Powered by vBulletin®. Copyright ©2000 - 2013, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.