Cisco 2600 radius authentication
I have a somewhat strange problem with a cisco 2600. I have the 2600
setup to provide dailin access on a DMZ to users that are
authenticated via RADIUS. When I telnet to the cisco from an internal
network ( also being authenticated by radius ) everything works fine
but if I try to log in via dialup more than a couple of hours after I
have telneted I don't get authenticated. Once I telnet from the
internal network I can login again via dialup. Is there some kind of
timeout in place ? Any ideas would be welcome.
|All times are GMT. The time now is 06:26 AM.|
Powered by vBulletin®. Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.