Unable to load Cisco 350AP Firmware
I accidently loaded a bad firmware which corrupted my Cicco AP firmware
which at the time was running 12.00T, once connected to the console
port via RS232 I get the following
l -- downLoad file into DRAM
u -- Upload file
p -- xfer Protocol
n -- coNsole
r -- Run
s -- System info.
I found this document which has been very helpful
I was finally able to upload a new firmware which is now in the DRAM
Memory Bank:File address size encoding type
a) DRAM :EnterpriseAP Sys 12.03 00009888 1196744 gzip Exec
b) DRAM :EnterpriseAP Web 12.03 0012DB50 148524 .tar.gz Web
c) DRAM :Inflate Ver. c14o 00151F7C 7556 gzip Dcdr
d) DRAM :AWC PCMCIA FPGA 0.14 00153D00 37380 none FPGA
e) DRAM :340 Series FWare 05.20U 0015CF04 58396 .tar.gz Data
f) DRAM :PC4800 Firmware 05.20U 0016B320 58392 .tar.gz Data
g) Config:AP Installation Key FE020000 64 none Key
h) Config:VAR Installation Key FE020040 52 none Key
i) Config:AWC_ConfigDB FE020074 528 AiroDB1 Data
When I try to copy the firmware files needed to boot my AP on the FLASH
mem I get the following.
** FLASH Write Error #5!
As you can see there is more than enough space on the flash mem so this
is not a space issue.
Memory Bank total used left
DRAM 16738168 1506992 15231176
Config 524288 644 523644
FLASH 7733248 0 7733248
Anyone know a way around this? The system was working 100% until I
goofed on trying to replace vxworks with ISO and now its a coaster.
Any help would be appreciated thanks.
|All times are GMT. The time now is 05:22 AM.|
Powered by vBulletin®. Copyright ©2000 - 2014, vBulletin Solutions, Inc.
SEO by vBSEO ©2010, Crawlability, Inc.